CD will not load

Take these steps:

1. Check to make sure the CD was burned correctly.

a. Take the "generic CD" that was shipped with the unit and see if that loads. If it does skip to Step 2.

b. Verify the CD was burned as a DATA CD.

2. If the CD was burned correctly try to reset the unit.

a. Turn the Sonorous off by switching the power switch on the rear to OFF.

b. While holding the reset switch on the rear of the Sonorous turn the power switch to the ON position.

c. After a few seconds release the reset switch.

d. The unit now has been formatted and is ready to be reloaded with the CD.

3. Verify the correct power supply is being used. The power supply should be at least a 1.6A, 15VDC, center positive power supply. If the wrong supply is used the unit may look like it is powered but when it is loading from the CD ROM drive it requires the extra amperage this supply can deliver.

Note: Sonorous Model 1 will not load CD's burned using the Windows Vista or Windows 7 file systems. If an incompatible CD is used, the LED Status will rapidly flash red & will not accept the CD.